Since its introduction, the Veracity HT3's have become our top-selling model. But the drivers are quite expensive and there is an incredible amount of labor that goes into every HT3 cabinet.

We often wondered if we could find alternative drivers and simplify cabinet construction (to reduce labor) to develop a speaker that provides similar performance at a lower cost. If so, it would certainly be a price-performance leader.

Dennis Murphy had heard good things about the 4" Visaton TI 100 midrange and suggested we take a look. If it measured well, it just might be what we were looking for. And sure enough, it measured extremely flat.

Since we obtained great results with the LCY pure ribbon tweeter in the Veracity HT2's, we decided to throw that into the mix.

The only remaining question was the woofer. We considered an 8" TC Sounds woofer similar to the 10" version in the HT3's, but the sensitivity of the 8" was simply too low. Then we noticed that Visaton also offered 8" woofers. So we thought we'd give them a try.

The combined results were very impressive indeed. As indicated in this plot , the frequency response was ruler flat (within 1 1/2 db from 35Hz to 25,000Hz).

The V3's frequency response is 32Hz to 60,000Hz +/- 3db. It delivers crystal-clear transparency on the top end, extremely accurate midrange capable of resolving minute details in the source recording and, at the same time, delivers deep, tuneful bass. What's more, it's imaging capabilities are difficult to put into words.

Check out the V3's specifications/cost.

That may sound too good to be true, but those are the goals we used to develop this world-class speaker system. And the results were better than we expected.

In short, the V3's faithfully and truthfully render the highest quality full-range sound your source equipment is capable of providing.

contact us

Because these systems are made to order, material and finish costs can vary greatly. Contact us for pricing on your custom Veracity system.